How long will the mattress maintenance once a year

This depends on the use fixed number of year of mattress, mattress is replaced every 10 years or so commonly, also can change the early oh of course, the mattress at the time of use and pay attention to the maintenance of yo. Keep health, fire, don't squeeze 1. Stay health mattress like sheets, regular cleaning, as far as possible in the mattress was a veil of dai li, the fitted like sheet change regularly; 2. Prohibit bounce mattress thicker, elasticity is very good, the mattress can bear the weight of people, but does not represent can bear the jumping ability of people, if too much jumping ability or long jumping, has the potential to damage of mattresses, bed frame; 3. Regular replacement of the left and right sides, the best every 2 - positive mattress Replacement of a mattress surface, three months can anyway, about a transfer, if a plane for three months, a year, just turn round this mattress to force uniform, prevent partial collapse. 4. Can't take when sofa bed not sofa bed, bed is for sleeping, not often on edge again, sitting on the edge of the bed for a long time, easy to make the edge damage of spring. 5. Tear outer plastic packaging if new mattess, in order to ensure to wear clean, new mattess is set with a whole new layer of plastic bags, shake off the plastic film before use, otherwise the mattress airtight, easy to tide, cause musty smell. 6. Moistureproof note had just finished washing bath or after sweating don't immediately lie down on the bed, can wipe dry and body; Indoor ventilation often avoid damp, to prevent the mattress lining mold, the spring rust inside the mattress, so as to shorten the service life of the mattress. Often get to dry under the sun. 7. Fire can't smoke in bed, mattress and bedding flammable, should be far away from the fire source; Can't use in bed appliances ( Such as DianRuZi) , so as not to damage the fabric or cause fire; 8. Don't squeeze, bend a temporary replacement mattress, mattress replaced under the mattress can't at the place, as far as possible the vertical erect, two sides not to be heavy extrusion, also don't store the bending, prevent deformation. ，。 If you think our reprint violated the Copyright Act or harm the interests of you, please do not hesitate to contact us, we will handle in time.