Points to note when installing a water mattress

Author: Synwin–Custom Mattress

Now people's requirements are relatively high, such as mattresses, there is a kind of water in it, which can help reduce fatigue, and at the same time can adjust the temperature to yourself, but due to its complex internal structure, installation time, we need to understand some specific details. Hard mattress manufacturers introduce that when installing a water mattress, you need to take out the bed cover, then unzip the zipper to let the bed cover lay flat on the bed. At this time, you can put a layer of quilt under the bed cover, which not only protects It can also play a role in thermal insulation. Then we take out the capsule and lay it flat inside the bed cover, with the two nozzles facing upwards, and adjust the position, connect the thermostat to the wires deep inside the capsule, place the probe under the capsule, and place the injection Lift and open the water and exhaust ports.

Then insert one end of the water pipe into the water inlet to start filling with water. At this time, pay attention to the water pipe head must be inserted firmly to prevent the water pipe head from rushing out of the water filling port and wet the bed and the ground due to excessive water pressure. At the same time, insert the exhaust pipe into the bladder The exhaust hole of the body begins to exhaust. When the water is slowly poured into the bed, use a prepared towel to wipe off some of the water droplets from the depth of the water injection port at any time. In the process of adding water, the gas in the bag should be exhausted as much as possible, and the gas can be exhausted as much as possible by extruding from the head of the bed as a whole to one end of the exhaust hole.

When the bladder is almost full but there is still a lot of gas in it, you can fold the water pipe and stop filling it with water. At this time, press the bladder as much as possible to push out the gas inside, and then continue to fill with water.